Your cart is empty.
Your cart is empty.Dudamath
Reviewed in the United States on September 2, 2024
I purchased these for lathe bar stock which required 0.25" nominal diameter. Application required close fit in 0.25" hole. Measured diameter was undersize at 6 mm (0.236 inches). Seller should update listing to clarify that this is metric bar stock, not inch bar stock. item returned. All other properties in description were correct.
Shackle Rustyford
Reviewed in the United States on September 1, 2024
I was very pleased to find these, happy with the price, and they are good quality... I'm cutting into smaller pieces for my application and will be sanding the ends so they look like glass.
Josh
Reviewed in the United States on August 29, 2024
These do not measure 1/4", they are a bit under and will be loose in a 1/4" hole. The metric equivalent would be 6.75 not 6mm.
Recommended Products