Your cart is empty.
Your cart is empty.Accumulators and Driers serve to remove moisture from an A/C system, and are a crucial replacement part for every A/C job. Whether the A/C system utilizes a drier or an accumulator, you can rest assured that the highest standards of quality and precision have gone into the design and manufacture of these products. We carry a large line that is sure to fit whatever application that you need.
Michael D Ambrose
Reviewed in the United States on May 19, 2024
Desiccant pack was the right size but the plug was too big. Luckily I was able to use the old one by putting a new O-Ring on it.
bill
Reviewed in Canada on July 8, 2020
did the job that it was suppost to do, highly recommend u change it when your a/c is 10 years or more.
Scotty
Reviewed in the United States on August 10, 2019
Installed this when I replaced my AC compressor. The AC is now the coldest it has ever been since I have owned this vehicle. You should always replace your drier whenever you open your system.
otis
Reviewed in the United States on June 22, 2019
I only needed the desiccant element, I think it shipped with the expansion valve as well which I didn’t need. Worked great, car is “cool” now.
Cindy K.
Reviewed in the United States on July 5, 2017
The dessicant bag was at least twice as large as the original and it clogged the system. Now I have to have the refrigerant removed to replace it.
Fang
Reviewed in the United States on July 29, 2017
Product worked well on a 2003 Odyssey. Had a slow leak in low side Schrader valve. Decided to do it right since R 134a is finicky when more or less than the exact amount of refrigerant is added or moisture has entered the system. Purchased part comes with 3/8 Hex Brass plug with O rings and integrated screen/filter which replaces OEM 10 mm Aluminum plug with separate filter. Lubed O-rings with PAG 46 (same as ND-8) purchased here ~ $5. Vacuumed down the system and it held 29 + mm Hg. Not sure about combining aluminum condenser with a brass plug due to potential of a galvanic bridge with Al condenser being the anode and thus the metal likely to corrode where there is contact. Hopefully the PAG 46 I used on the threads will break the electrolytic bridge.
Scotcher
Reviewed in the United States on April 6, 2017
Fits 2008 Pilot well.
JUDY SMITH
Reviewed in the United States on October 13, 2016
good
Adam E. Mis
Reviewed in the United States on August 8, 2015
Sometimes you will need to buy whole dryer if bolt doesn't come out. But it did and worked great
Recommended Products
$22.67
$ 11 .99 $11.99