Shopping Cart

Your cart is empty.

Your cart is empty.

Tuner's Quick kit wiring Vibration Bracket GENUINE MAC 3 port solenoid Boost valve 35A-AAA-DDBA-1BA

Free shipping on orders over $29.99

$49.90

$ 23 .99 $23.99

In Stock

About this item

  • includes GENUINE MAC valve
  • Quick install: Lever nut wiring connector allows fast installation for tuners, simply strip wires 1/4", insert wire and close lever . Note the red and black wire in the picture would be YOUR wires from your controller (so not included)
  • Strain relief tie hole for controller wires.
  • Hard anodized 6061 Aluminum CNC bracket made in the USA. NOT plastic!
  • Non tabbed (no cantilever) provides more secure mounting ,more compact, less possibility of vibration.
  • M6-M6 female threaded rubber vibration isolators stainless fasteners. Isolators' flexibility allow mounting to mildly non-planar surfaces like the engine bay side of wheel wells.
  • You will receive everything shown in the image that shows unused zip tie lying in the foreground, so 3x brass elbows AND the vent and everything else in that same image.. Except not assembled.
  • 90 degree barbs allow much neater hose routing (Allows parallel gathering of hoses)
  • TIP!: USE THREADLOCK ON THE CONNECTOR MOUNT PHILLIPS HEAD SCREW AND SNUG IT DONT OVER TIGHTEN.


Coil Voltage: 12 V-DC Port Size: 1/8 IN Frequency range 10-30Hz. . Note: The valve will be marked/identified in some way to ensure that it was sourced from Circuit Se7en and is a genuine MAC valve.


Recommended Products