Shopping Cart

Your cart is empty.

Your cart is empty.

Swess RV Roof Vent Lid Cover for Jensen Metal Roof Vents Suitable for 13 * 13 Inch Motorhome Roof Vent Cover Camper Trailer

Free shipping on orders over $29.99

$24.99

$ 11 .99 $11.99

In Stock

About this item

  • ✅►【IMPORTANT NOTE】 - This camper roof vent cover is 13" x 13" ,compatible with Jensen RV Vent and comes completely assembled.
  • ✅►【Aerodynamic design】-- The low profile aerodynamic design provides high flow ventilation, fresh air circulation in the RV.
  • ✅►【Reinforced Center Rod】-- Fully adjustable with a reinforced center rod and a long continuous hinge for excellent stability of the RV roof vent cover.
  • ✅►【Premium Quality】-- Made of durable, impact-resistant polypropylene,not only can the fresh air into the car, but also effectively block the UV rays, prevent rain and leaves into. The product is not sponsored or endorsed by ,or affiliated with the brands it fit,including Jensen


RV Vent Cover Fits for Jensen 13" x 13" RV Vent. Made of durable, impact-resistant polypropylene,not only can the fresh air into the car, but also effectively block the UV rays, prevent rain and leaves into. The low profile aerodynamic design provides high flow ventilation; fresh air circulation in the RV


Nishi
Reviewed in the United States on August 18, 2024
As another reviewer stated, Swess did not think through the replacement installation. Apparently the company doesn't read these reviews because two years later they are still using rivets instead of screws. Perhaps they just don't care.
David Jean
Reviewed in the United States on March 22, 2024
The slide for the crank that raises and lowers the vent is very thin and bent. Had to remove that part and use the old part. Would not buy again.
Kyle
Reviewed in the United States on August 17, 2023
Product fit great on the 13x13 electric crank trailer vent.
Mike Talaski
Reviewed in the United States on June 28, 2023
Drill out 2 rivets instal original screws, all work done from the top.
T. Addison
Reviewed in the United States on June 1, 2022
My old smoke-colored cover had partially melted in the sun; I'm hoping this new one will stay a little cooler due to being white.This new cover was an exact fit for my fan, but the install was more difficult than it should have been because the metal lift bar is fastened to the plastic cover with rivets instead of screws. This makes it impossible to mate up the new bar with the lift mechanism without disassembling the fan from the inside. I'm docking a star for this.Instead of dropping the whole fan down, I drilled out the rivets and replaced the metal bar with the screw-on one from my old cover. That allowed me to install it single-handedly from the outside. Fortunately the new and old bars were exactly alike, including the hole locations.
Gatt
Reviewed in the United States on October 23, 2022
Fits like a glove, and super easy to install.
rhamrick
Reviewed in the United States on January 10, 2022
Works
p taplin
Reviewed in the United Kingdom on June 19, 2021
Perfect replacement original on my toyota hiace camper.
Rhonda Johnson
Reviewed in the United States on May 19, 2021
Item as described. Easy to install. Timely shipping. Seems to be fair to good quality cover
Recommended Products