Your cart is empty.
Your cart is empty. Complete with interior liner and barb for a drain hose.
90 degree angle.
2" outside diameter.
1 5/8" inside diameter.
9 inch length with stop pin.
Flange footprint is 4 1/4 x 3 3/8 inches.
Complete with interior liner and drain barb.
Highest-quality, solid cast 316 stainless steel.
Jose Wilson Garcia Delgado
Reviewed in the United States on January 2, 2025
El producto si es acero inoxidable, resistente al agua de mar.
Tom
Reviewed in the United States on October 26, 2024
Have had them for 5 years now still look good and work great
Cadplot
Reviewed in the United States on August 3, 2021
Very well designed, great material, easy to install. Made a great difference on my Jet Boat. Thanks. Thinking to install a 30-degree version in the front of the boat.
Steve Nichols
Reviewed in the United States on March 17, 2019
This is made of high quality products and well worth the money. The only complaint or suggestions I have is please add a cutting template to the package for ease of installation.
MaxItUp
Reviewed in the United States on July 20, 2018
These looked very well made and heavy construction. Unfortunately I could not install these are they were 90 degree holders.Observation for buyers:-These do not have a rubber gasket to place between the flange and boat-Waster accumulation is possible as the bottom is closed and not open as the stock ones on my boat-Screws are not provided
Edward Lance Wagner
Reviewed in the United States on August 18, 2016
Here's my take on the rod holders. They are of good quality and sturdy. I will see how long they last. I will mention like others here that the base is not perfectly flat but silicone will make a perfectly good seal. I did have an issue with the first pair I received and would recommend looking closely at the bottom where the drain has been welded to make sure it is a good weld and not cracked.
Brian L.
Reviewed in the United States on April 25, 2016
They appear to be the same quality as much more as much more expensive ones. Fit right into the holes as the ones I was replacing. I also used 2 1/8 inch whole saw to add two more sets. All work and look great. Only negative was they don't fit completely flush just a little off on every set so I used silicone around them.
Ed Smith
Reviewed in the United States on November 30, 2013
Bought 8 of these to install on the sides of my center console (Contender 28T). They are VERY well made and look awesome. The Lee's rod holders (with the hose barb) are 3x the cost, and honestly, I cannot tell any difference in the quality of the two... Excellent deal and an excellent product...The hose barb accepts ½ ID tubing.
Recommended Products
$22.99
$ 10 .99 $10.99