Your cart is empty.
Your cart is empty.
Set of 2 front brake caliper rebuild kit for the Honda models listed with NISSHIN brake calipers.
Stock calipers have a tendency to become corroded and the piston can seize inside the caliper. If you're rebuilding your front caliper it might be time for a fresh rebuild kit, especially if the original piston is pitted. Ride safe and brake with confidence!
NOTE: Check VIN # range for your model listed below, brake calipers changed from year to year.
Kit Includes:
Piston x2: 45107-410-006 - Diameter 38mm / Height 35mm
Piston Seal x2
Piston Dust Seal x2
Dust Seal Clip x2
Pin Boot x4
Bleeder Cap x2
Installation Tips:
Make sure to thoroughly clean the channel in the caliper that holds the seal, if there is any built up grease or dirt it will not allow the seal to sit properly which will affect the pistons ability to engage and retract.
The darker side of the piston with the indented ridge faces the brake pad.
Use brake grease between the piston and the pad but do not allow any grease or brake fluid to come in contact with brake pads. (this kit does not come with pads)
Fits Honda:
CB750F Super Sport - 1977-1979 - Front (1 set needed)
CB750F Super Sport - 1980 (VIN# RC04-2100003 TO RC04-2116089) - Front (1 set needed)
CB900C Custom - 1980 - Front (1 set needed)
GL1000 Gold Wing - 1978 - Front (1 set needed)
