Your cart is empty.
Your cart is empty. Parameter:
Measuring range: 0.00V-30.0V.
Power supply range: Red DC4.50-30.0V ,Blue DC50-30.0V
The highest input: DC30.0V. Note: The input voltage is higher than 30V and may be permanently damaged!
Allowable error: +/- 1%; (the error is ±0.3V when it is greater than or equal to 10V; the error is ±0.10 when it is less than 10V)
Input impedance: > 100K ohms
Working current: Refresh rate: about 300mS once
Display mode: three 0.56" LED digital tube
Display color: red, blue
Lead length: 20cm
Dimensions: 48 x 29 x 22 mm, length X width X thickness (without mounting ears);
Mounting hole: 46 x 27 mm
Net weight: 20g
Working temperature: -10 ° C ~ 65 ° C
Package Included:
NOYITO 2Pcs 0.56" LED DC Digital Voltmeter
Hunter G
Reviewed in the United States on March 28, 2025
One arrived damaged. The other works nice and the display is nice and not too bright inside at night. Needed two; got two but only one works.
Arron C.
Reviewed in the United States on September 14, 2024
Item arrived on time and works exactly as its suspected too.
Tom
Reviewed in the United States on May 19, 2024
Second time I purchased these meters. I use them for measuring under a half a volt. These match my fluke DVM exactly. The first buy were not as good so maybe they have been improved. Limited sample size but I think in general these perform better reading over 5 volts rather than the low voltage.
Edurts
Reviewed in the United States on January 23, 2024
All 4 were no where close to each other. Tested on a 12v battery charging at 14.1v on a fluke multimeter, I got readings from 3 volts to 8 volts. One just didn't even work.
Luigi Petrigh
Reviewed in the United States on August 31, 2022
A decent, reasonably accurate panel meter gauge. Reads within 0.05v of a calibrated fluke meter.
James hartman
Reviewed in the United States on June 7, 2022
One of the two did not work. **The company was very helpful in making sure the item that was not working was replaced. They offer a manufacturer 1 year warranty. Very pleased with the customer service.
Tom
Reviewed in the United States on May 15, 2022
The cut-out size is 1" x 1.75"
Steven G.
Reviewed in the United States on August 24, 2020
These are very good add on volt meters. They are exactly as described and are accurate. If you're good at soldering then these will do the trick. I'm not a good at soldering, so I purchased some small insulated alligator clips. These meters are bright red and won't kill your night vision (I use mine in an observatory on a couple of motor drives running on batteries). I'd buy them again since they are priced right and arrived very quickly.
Recommended Products
