Shopping Cart

Your cart is empty.

Your cart is empty.

MECCANIXITY 6Pcs Brass Brazing Rods Flux Coated, Phosphor Copper Solder, Low Temperature Welding Sticks 3/32'x9/64'x20' for Copper Repair, Hvac

5.0 Write Review
Free shipping on orders over $29.99

$26.29

$ 13 .99 $13.99

In Stock
  • The HVAC tools and equipment are used for brazing copper in motors, air-conditioners, meters, and refrigeration industries. Brazing rods flux coated can braze some pipes or the small copper braze job and the art project. The low-melt solder is widely used for DIY craft drift punches knife handle lathes.
  • Size: 2.5 x 3.6 x 500 mm/0.1 x 0.14 x 19.69 inch (ID*OD*L); Welding Current: 90-220(A); Melting Point: 870~900℃/1598~1652°F; Color: White coating, (ID*OD*L); Welding Current: 90-220(A); Melting Point: 870~900℃/1598~1652°F; Color: White coating, Copper core; Style: Round Straight Bar; Material: Brass and flux coated; In the package of: 6PCS x Welding Rods
  • 1.This is a flux-coated brazing rods, so no additional flux is required during welding; 2.The flux is evenly distributed, has good continuity; 3.The welding stick will not get tangled during welding and will not block the conduit; 4.There is less spatter and smog during welding, and the solder joints are firm; 5.Good fluidity during welding, strong-caulking, and can flow into small spaces.
  • 1.Clean the surface of the copper material to be welded; 2.Insert the stick into the welding gun or pen, and adjust the welding current and power as needed; 3.Contact the welding stick with the copper material to be welded to melt the contact; 4.Remove welding slag and remaining stick after cooling.
  • Manual measurement, please allow slight errors on size. Before using these brazing rods, please keep proper ventilation, adhere to recommended temperature ranges, and wear appropriate safety gear during use.


Product Description

Copper Brazing Rods for Copper Repair Hvac Refrigerator

Copper Brazing Rods

  • The HVAC tools and equipment are used for brazing copper in motors, air-conditioners, meters, and refrigeration industries
  • Brazing rods can braze some pipes, the small copper braze job, and the art project
  • The low-melt solder is widely used for refrigerator copper tubes, air conditioner copper tube welding, copper product welding, DIY craft drift punches, and knife handle latches

Widely Application:

  1. Welding of refrigerator copper tubes
  2. Air conditioner copper tubes
  3. Copper water pipes
  4. Suitable for the electromechanical industry

Advantage:

  • the welds are firm
  • evenly distributed
  • good continuity
  • less spatter and smoke during welding
  • can flow into small spaces

How to Use

1. Clean the surface of the copper material to be welded

2. Insert the stick into the welding gun or pen, and adjust the welding current and power as needed

3. Contact the welding stick with the copper material to be welded to melt the contact

4. Remaining stick after cooling

Note:

  • maintain ventilation
  • adhere to temperature ranges
  • wear safety equipment