Your cart is empty.
Your cart is empty.Product Description
24v switching power supply is built to be sleek and portable, making it easy to install and carry around for various needs. It supports a wide input voltage range of 110-250V AC, delivering stable and accurate power output.
Comes with multiple safety protections, including overload, over-voltage, over-temperature, over-current, and short circuit protection. Features hiccup mode and auto-recovery to ensure smooth operation after any issues are resolved.
24v dc power supply driver using high-quality aluminum, hollow surface, greatly improve the heat dissipation and prolong the service life. No cooling fan, no noise.
24V switching power supply dc transformer with small size design, both beautiful and space saving and widely used in a variety of 24V LED lamps (<150W).
Dan B.
Reviewed in the United States on March 14, 2025
This little PSU has some braun - 400W at 24V is nothing to frown at.I've used smaller versions of this for some LED strips, but this will replace my failing 3D printer PSU. I wasn't sure I'd be able to find too many supplies at this current, but this is sure it.
M. D. Patterson
Reviewed in the United States on February 18, 2025
If you have some experience in electricals ( ac & DC) helps in installing.
David Burnett
Reviewed in the United States on January 24, 2025
Does what it's supposed to - converts AC to 24v DC. The 1.5A is fine for short LED runs, or for a few cabinets/shelves that are separate from a bigger LED run. One of the plusses of the 36W / 1.5A unit is that it's very thin and thus easier to hide in sneaky places. As it turned out, I needed a lot more power than 1.5A, so I wound up using other transformers for where I'd planned to use this device. And it's important to have at least 10% reserve, so don't hook up enough LEDs that you're pulling 1.5A total on this transformer, I wouldn't exceed ~1.3A.
Shih-Shin Chou
Reviewed in the United States on January 16, 2025
There are multiple DC outputs on this power supply. Easy to use. doesn't get hot. Nice table top unit.
Austin w
Reviewed in the United States on August 23, 2024
Decent contacts. Solid metal and doesn't get to hot
Ben Kuykendall
Reviewed in the United States on August 18, 2024
I can't complain, it works and was easy to install. But - it does have a lag from power on to the light strips turning on.
EvolMTB
Reviewed in the United States on July 25, 2024
Sharing the following information to help with your buying decision.I bought this driver to replace a same spec driver in a light fixture that was failing. Sometimes it would not turn on. While the old driver had a virtually instantaneous setup/rinse time (time from when the switch is turned on until the light starts emitting), this driver has an approximate setup/rinse time of 1 - 1.5 seconds. It may not seem like much but for a kitchen light, it is long enough to feel and makes you question if you hit the switch or not.Since this is an overhead light fixture and not the easiest to remove and reinstall, I haven’t decided if the annoyance justifies the removal and return on this driver to find another one. This does not seem to be a specification that is shared for drivers so it makes it a gamble if I choose to replace this one.On the positive side, this driver is 1/2 the width and 1/2 the thickness of the old driver.
Bill Hodges
Reviewed in the United States on June 28, 2024
Replaced the driver in my huge led ceiling light. So far it’s working great. It does have a delay of a second or two when you first flip the light on.
Recommended Products
$23.99
$ 12 .99 $12.99