Your cart is empty.
Your cart is empty.The Hobie Thru Hull Wiring Kit allows you to thread wires through the hull of your boat to install fishfinders, GPS and more. The kit includes two through hull fittings with a variety of options for different wire sizes, backing nuts, o-rings, and installation instructions. Also includes two solid grommets to block off the opening if you want to remove your electronic device.
Michael Brooks
Reviewed in the United States on July 19, 2024
Exactly what I needed. Plugged my holes right up!
Customer
Reviewed in the United States on June 1, 2021
Worked great and went in smooth. Looks professionally done with a DIY price.
B-MAN
Reviewed in the United States on April 19, 2019
A must have if you want the cleanest water resistant exit/entry point for marine electronics. Looks great and works just as well. Includes everything to install and even a plug cap if you change your mind.
Placeholder
Reviewed in the United States on September 12, 2018
I know this is a Hobie product and my Kayak is an Old town but this was the best thing out there for doing a clean install. Well made and for the price made my home install of my fish finder look professional. Its easy to use and with all the choices of inserts I am sure you can find one to use with your cables as well. Hobie does it again!
Christopher Healy
Reviewed in the United States on May 1, 2018
Great kit for running the transducer and power cables for my lowrance hook 4x, the cable ends just barely fit through the nut but they did fit. The instructions that came with it were short but straight forward. i did have to pull the wires twice due to forgetting to put the nut over the cables before i went for final assembly.
Kevin F
Reviewed in the United States on September 5, 2016
This kit makes running wires through the hull, easy. With all the options for wire size means you stay water tight no matter the size of the cord used.
nickm
Reviewed in the United States on June 29, 2016
Hobie makes solid products. I used this for my fish finder and it was perfect for my setup. This always a clean looking install and water tight seal. I'd highly recommend this product for anyone needing to drill holes.
Mondo
Reviewed in the United States on July 3, 2015
Well, not sure if it's fair for me to rate it just a 3 but for me but I can't use it for my needs. I have a Lowrance 5 elite fish finder. The power cables works just fine of course since nothing but wire is hanging off one end. My battery is inside the hull of my kayak. However, the transducer has a connector that is just a tad too large for the tightening screw on the thru hull connector. So for me specifically with the type of FF and thru hull mounting, it won't fit. If I do make a thru hull transducer install, I will have to get another connector.Update* I was able to make the locking nut pass thru the transducer cable. I forced it thru. I looked at the nut after and it did somewhat mess with the threads a little but it was still able to screw in and lock it down. Changing from 3 to 4 stars.
Recommended Products
