Your cart is empty.
Your cart is empty.Control Arm Bushing Set; Red; Front; Must Reuse Existing Outer Metal Shells; Performance Polyurethane;For both front and rear of suspensions on cars, trucks and SUVs. Made of Energy’s Hyper-Flex performance polyurethane for optimum performance and durability. Maintains proper alignment under extreme conditions on the street, track or off-road. Improves vehicle handling, cornering and overall control. Full floating for smoother, efficient operation. Outlasts and outperforms rubber.
ronald s.
Reviewed in the United States on January 5, 2019
Great
CAMAL F.
Reviewed in the United States on April 7, 2019
Use it on my d21 pathfinder works like a charm
Enrique Vazquez
Reviewed in the United States on June 13, 2015
Excelent
ELias Akiki
Reviewed in the United States on May 24, 2015
Good it's fit for Nissan pathfinder terrano 1993.
Jacob
Reviewed in the United States on January 21, 2014
Replaced all bushings in front end including these. I love the feel, far tighter around corners and will hold an alignment much better than the old bushings in my '97 Nissan Pickup XE 4x4. You definitely feel the road more, but for me that is a good thing. Drives more like my BMW 330 now, whereas before if felt like driving a boat. The old bushings likely original with 208k on them..Installation:Upper: Easy enough: you can get upper bushings out with a press easily enough, and wire cup attachment on a drill will clean out rust and grime. I had to use a cutoff wheel to cut old sleeves off, they were fused on.Lower: HARD. You have to get inner sleeve and bushing out without damaging outer sleeve which you need to reuse. I used the largest drillbit I could and drilled all the way around the bushing from both sides. I kept at it and worked it around wallowing out as much as I could. After about 20 minutes straight, you can get the sleeve out. From there, I used a 1" knot wire drill attachment (www.amazon.com/DEWALT-DW4902-1-Inch-Performance-0-020-Inch/dp/B00004YMDG). Keep at it till all the old rubber is gone and the sleeve is shiny clean and smooth. New bushings slide in with some persuasion of a large C-clamp. I installed them with the sleeve, but as it is wider than the bushings, it would work better to install directly with C-clamp then push the inner sleeve in.
Stacey
Reviewed in the United States on November 11, 2013
Installs nice, really stiffened up the ride and handling. I wouldn't recommend these if you are looking for less road vibration. Being a poly material they are tighter than the rubber style, but with that, you will feel the bumps a little more.But the improvement in handling is well worth it. Be sure to coat these with anti-seize liberally or you may get some squeaks.
CA Shopper
Reviewed in the United States on April 7, 2012
I replaced all the bushings on my 93 Nissan pickup with 205k miles. These fit nicely and no more suspension squeaks.
Recommended Products