Your cart is empty.
Your cart is empty.Product Description
DPP Titanium Dovetail Mount Compatible with Smith Wesson MP Holosun 407K/507K,Shield RMS,Sig Romeo Zero
DPP Titanium Rear Sight Mount Compatible with Smith Wesson MP
Remove the rear sight and replace it with our mount in order to mount your red dot sight. You can take our mount off and replace your rear sight at any time.
Update to 30MOA, Solved some red dots don't have enough elevation adjustment to put the sight down.
Please note that S&W slide dovetails are known to vary in dimensions. And filing with a diamond file or hone may be necessary for proper installation. Our plates are made to the same tolerances, and while they are intended to fit snugly in most slides, the same sight may slide through a particular slide or be too tight to start into another. We can't control the slide dimensions, all we can do is keep our plates a constant size.
Any issue during installation or use of this product, please contact for replacement.
ATTENTION:
Get ready to catch the spring and cap under the rear sight when you remove the rear sight.
Compatible models
Compatible Red Dot Sights
mounting Screws included
- Holosun 407/507K
- Shield RMS/RMSc/RMSw/SMS
- Romeo Zero
- Leupold DeltaPoint Pro
- Swampfox Sentinel
- Crimson Trace 1550
Note
The Leupold red dot will be 0.2 inches longer than our adapter plate, so it will protrude 0.2 inch
Compatible With Smith Wesson
MP Full Size/Compact/ Shield
MP 2.0 Full Size/Compact
MP Performance-Center Series
MP 22 Full Size
SD 9/40 VE
Does NOT compatible
MP C.O.R.E Series
MP Shield EZ Series
MP .22 Compact
SW 9/40VE
Paul M
Reviewed in the United States on February 7, 2025
Easy to install. Used on mp 22 full size. The extra weight with optic causes malfunctions but a supressor adds proper back pressure and functions great.
Blake
Reviewed in the United States on February 7, 2025
if you’re looking for an easy solution that doesn’t involve hundreds of dollars to pay for someone to mail your slide and the risks that come with that this is an amazing product. The customer support is fantastic as well. As someone who finally took the plunge to get a reflex on one of my pistols and knew nothing about the process, they were extremely helpful with explaining everything to me and helping me make the right decision when it came to which models to purchase a hint, especially with advising me to have a gunsmith do the actual install of it. In the end between the cost of the Smith installing and bore sighting the reflex for me, I was all in for less than 80 bucks. If I’d had the slide milled I would’ve been looking at at least 200 to 250. The only downside is it sits slightly higher than it wood on a mill slide, but after two trips to the range for practice, I was used to the sight picture and it wasn’t an issue at all.
Larry V.
Reviewed in the United States on February 3, 2025
Fit my M&P Shield Perfectly
MizutheWolf
Reviewed in the United States on February 26, 2025
Fits just right on the SD9VE, had a holosun green dot on it and its great! Pretty heavy duty.
Bootstux
Reviewed in the United States on February 20, 2025
Solid 9/10
devin
Reviewed in the United States on February 18, 2025
Good quality
Ed
Reviewed in the United States on January 27, 2025
I mounted this onto a Ruger 9mm easy. It was a snap to install. Made from aluminum and quite solid.
Baylee
Reviewed in the United States on November 19, 2024
Great for conceal
Recommended Products
$17.95
$ 7 .99 $7.99