Your cart is empty.
Your cart is empty.This adapter can help you save money and CO2 by allowing you to remove 88g CO2 capsules from your airguns without releasing the remaining air. Moreover, it allows you to use the same 88g CO2 capsule in different airguns. Instead of wasting gas, you can remove the capsule with the adapter attached after a shorter shooting session and reuse them later. This also helps prevent o-ring and seal damage caused by leaving CO2 gas in an airgun for a long time. The adapter is made of solid aluminum construction and equipped with high-quality o-ring seals. Please note that the package only includes the adapter and does not contain CO2.
John wiggins
Reviewed in the United States on September 21, 2024
This has taught me a lesson about the consequences of not reading reviews, there were two reviews one said it was great, the other was quite forceful and detailed about the specific problem with this item. The bad review was spot-on and it has ruined a 90 gram cylinder that was around nine dollars. Terrible, don't buy
Riley
Reviewed in the United States on June 28, 2024
I installed a 90 Gram Co2 cartridge, installed it on my marker, and nothing. No air supply. Removed the adapter and cartridge, installed a plain 90 Gram Co2 cartridge and the marker worked perfectly. After removing the first cartridge from this adapter, I found out that once the cartridge was pierced, there was too much pressure to allow the pin to release and charge the marker when installed. Waste of money. There are PLENTY of BETTER options on here that do the same thing. DO NOT BUY THIS ONE!!!!!!
Recommended Products
