Shopping Cart

Your cart is empty.

Your cart is empty.

Brush Research 3 1/4' (83mm) Flex-Hone Cylinder Hone Tool 180 Grit (Silicon Carbide)

4.6 (6) Write Review
Free shipping on orders over $29.99

$38.99

$ 19 .99 $19.99

In Stock

About this item

  • Flexible Cylinder Hone made of Silicon Carbide
  • Hone is Made in USA by Brush Research Manufacturing
  • Hone is self centering and can be used with 3/8" or 1/2" chuck drill
  • Perfect for bore honing and cylinder refinishing
  • The hone size listed on the product is the bore it is intended to be used for (or slightly smaller bore will work)



KDK800
Reviewed in the United States on April 29, 2022
I've used the hone a couple a times so far, it produces a very nice finish.
Kenneth Burton
Reviewed in the United States on October 6, 2021
Used these to hone in on the Kellogg compressor cylinder sleeve, it did the trick after many many honings
AirCooledShop
Reviewed in the United States on September 4, 2017
Ive rebuilt two engines using this flex hone and worked perfectly. Provided the necessary cross hatch pattern for a successful break-in. Highly recommended!
Theodore R. Roach
Reviewed in the United States on April 21, 2017
Used it on a 2002 Audi A4 1.8t..........easy to use and worked great!
Justin
Reviewed in the United States on February 27, 2015
Perfect size for my 1.8t AWP engine. Chucked it up into a power drill with a known RPM and honed my block myself. It was my first time and I've since put 20k my motor... Zero compression issues. Lubricated it using ATF.
Fabricio
Reviewed in the United States on June 10, 2013
If you don`t have out of round cilinders, this is the tool to deglaze the surface cilinder's walls. Assume it can be necessary to finish the surface with 240 grit (fine) hone before assemble new rings.