Your cart is empty.
Your cart is empty.Johnson Duramax BOSS Brass cutless bearings adapt equally well to strut and sterntube mounts and are often used efficiently as rudder stock and pintle bushings. Johnson Duramax BOSS Brass cutless bearings use a specially forumlated oil and chemical resistant nitrile rubber that is bonded to the shell. Johnson Duramax Marine is the world's largest supplier of marine bearings and each is made in the USA. Order your BOSS Bearing today. The measurements for the BOSS cutlass bearing are Shaft Size: 1-1/2 inches Outside Diameter: 2 inches Length: 6 inches
Robbin Smith
Reviewed in the United States on August 28, 2021
Drive shaft bearing for sea ray boat. Shipping was slightly slow, but not surprised in this economy, lately. Fit, finish, and quality was right up to speed. Good work.
Emily
Reviewed in the United States on May 25, 2020
These cutlass bearing where a perfect match and we were able to get them onto the shafts as nice as you could ask,
Recommended Products
