Your cart is empty.
Your cart is empty. Black Aluminum Rear Sprocket Pulley Spacers For 2000-Up Harley Davidson Motorcycles
*** VERIFY THE LIP ON YOUR HUB IS LESS THAN .300" TALL OR THESE WILL NOT FIT ***
Made from billet 6061 aluminum bar stock. Available in graduated sizes for proper spacing when installing oversized custom wheels. Made to fit most 2000 and newer Harley Davidson and custom motorcycle wheels. Typically these fit hubs with sealed bearings, not Timken tapered bearings.
Self-centering design properly locates the spacer to the wheel and the pulley or sprocket
Bolt hole size: .453"
Bolt hole pattern: 3.25" x 5
Counterbore that fits over hub lip: 2.216" I.D. X .300" deep (Except 1/4" spacer is .215")
Step that sprocket/pulley fits over: 2.208" O.D. X .188" tall
Center hole: 1.56"
Outside diameter: 4.19"
Used with sealed ball bearings
Fits 3/4, 25mm, and 1" axles
Made in the U.S.A.
Made in the USA
Tovya Griffith
Reviewed in the United States on July 4, 2024
After a little delivery hiccup...I got the part and fits right on...worked perfect for a 1.25" rear pulley offset... nicely machined anodized aluminum part...2016 Harley Davidson fls...
Jeff
Reviewed in the United States on October 22, 2022
This spacer is a high quality item. It is perfectly machined and finished. Fit my 07 Dyna with my new custom wheels and 70t pulley. All non-HD branded pulleys need a spacer for proper drive belt clearance, and the size will vary based on wheel hub and tire width. This part certainly gets the job done. The engraved text is a nice touch!
Recommended Products
$14.94
$ 7 .99 $7.99