Your cart is empty.
Your cart is empty.Product Description
SUKOUSRAM Bike Brake Shift Levers Hoods
Durable Bike Levers
- Soft and comfortable hand grip,can absorb vibration and reduce hand fatigue during long-term riding.
High Quality Made
- Made of high-quality silicone, soft and friendly material,with better durability, strong toughness
Easy Installation
- Easy to install,Anti-Slip designed,the smooth surface has better hand grip for performance.
- Compatible with ST-5600/ST-5601/ST-6600
- Compatible with ST-6700
- Compatible with ST-R7020/ST-R7025
- Compatible with ST-R8000/ST-R8020
Check Your Model Number First
Model specific for the perfect fit,check your bike brake shift model before order.
scmrak
Reviewed in the United States on August 25, 2024
After 30K miles and a couple of handstands, one of my hoods had rotted away. I bought these as a replacement for my Ultegra 6600 shifters. The fit is spot on.Some hints for potential buyers: Shimano stamps the model number on the base of the shifter (at the handlebars, under the trailing edge of the hood). Check the model number before ordering; these are NOT compatible with other models not listed by the maker. Getting them on requires that you either remove the shift cable or take the shifter off the bike and remove the brake cable. The fit is VERY tight, but soaking the hoods in hot water will allow them to stretch a little. Have funt!
Eric in Cincinnati
Reviewed in the United States on November 22, 2024
arrive quickly and as described. The installation is difficult since the cables have to be removed.
Ashley
Reviewed in the United States on January 8, 2024
Fit them on my ST-5600s. They fit just fine. They don't have any texture whatsoever, unlike the originals, but I suspected that would be the case as these were the cheapest available at the time.
Tharun Prakasam
Reviewed in Singapore on April 11, 2024
Fits perfectly
Unhappy Customer
Reviewed in the United States on November 1, 2023
The product fit perfectly. I was thrilled with the look and feel. I bike 15 miles a day so I put these to the test. Here is a note on the installation. You only need to loosen the shift cable of the grip you are replacing. You don't need to touch the brake cable. You pull the cable out up to the upper cable stay. There is no need to remove the cable cover above the upper stay and you do not need to remove the cable from the shifter. The cable covers are very flexible and can be stretched over the shifter and then threaded over the shift cable that is hanging down. To install the new cover I used hand sanitizer to make it slip on easier. Be patient and it will slip on and fit nicely.
Recommended Products