Your cart is empty.
Your cart is empty.101101
Reviewed in the United States on April 22, 2024
Some sprockets have holes to mount on disk brake hubs. This appears to be a disk brake hub and it works with my sprockets. I needed 6 washers to keep the sprocket from hitting my frame, but it works fine now.With a 26" rim, we used 254 mm spokes in the 2 cross configuration and it works fine.
Eric Flynn
Reviewed in the United States on September 24, 2022
This hub is a good idea, but very poorly made. Nothing is concentric to the axle. So everything runs eccentric/wobbles relative to the axle, and in different ways. The flanges are not square to the hub. The cartridge thread is not square. This all makes for a wheel that is impossible to get to run true. The same hub, machined from aluminum, with sealed bearings, with a flange for 3 hole 80mm sprockets would have been much more ideal. Pretty much unusable.
Ethan Valencia
Reviewed in the United States on June 13, 2021
Make sure to purchase all the necessary components at once including the free wheel, also I am using this for a motorized bike and would like to say, make sure you have the correct parts before assembling it all
Benjamin Hanemann
Reviewed in the United States on March 25, 2021
Works perfectly, allowed me to have sprocket and large disc brake rotor.
Branden Braden
Reviewed in the United States on February 2, 2021
I didn't measure my bike before buying and product was two inches longer than my frame could accept, but a floor jack made plenty of room
Michael
Reviewed in the United States on July 29, 2020
So far so goodUsed old spokes, nipples, rim tape and rim
Manuel de jesus
Reviewed in the United States on November 8, 2020
Es bueno presta el servicio que debe prestar
Will
Reviewed in the United States on January 27, 2020
I user theses hubs for motorized bike builds. The 6 holes in each side give me a good variety of mounting options for brakes and sprockets.
Recommended Products