Your cart is empty.
Your cart is empty.Product Description
Compatible with Lexus Models:
- 2007-2009 RX350 V6 3.5L
OEM Number: 4441048180, 3404374
Location: Pump to Gear/Rack Pinion
Quantity Sold: One Piece
Specification
- Bracket Included: No
- End 1 Fitting Size (MM): 16
- End 1 Fitting Type: Banjo
- End 2 Fitting Size (MM): 16
- End 2 Fitting Type: Male O-Ring
- Hose Material 1: CSM
- Length (IN): 58
- PS Switch Port: No
Mike M
Reviewed in the United States on August 25, 2023
installed on a 2007 lexus rx350. the oem power steering high pressure line was leaking at both of the rubber hoses. This one fit and seems to be working fine so far. Under the hose cover, it is labeled as sunsong. comes with the rubber o ring for the rack fitting. I had to remove the 3 mounts from the oem line and re-install onto this line. After looking at some youtube videos, it seems like it as a job I can do and it went without a problem. remove one screw behind the intake manifold, one behind the throttle body, one above the steering rack above the fitting and one above the power steering pump above the banjo bolt. Hardest part we snaking the old line out and snaking the new one back in. Make sure you remember how the hose goes up/under/around hoses and the o2 sensor. FYI, if you have a hard time getting the mount above the banjo bolt to line up, position the hose as close as possible to where it will meet up and then tighten the banjo bolt. it will back installing the screw for the mount above the banjo bolt a lot easier. Hope this new hose lasts. I will try to update if anything goes wrong.Hope this helps. Thanks
Maged lotfy mohamed
Reviewed in Saudi Arabia on April 16, 2023
مطابق للوصف ورقم القطعه
Recommended Products