Your cart is empty.
Your cart is empty. Brand New HVAC Heater Hose Elbow Connector (Aluminum)
For Intake Manifold To Belt Tensioner, Includes O-Rings, and Upper and Lower Elbows
These tubes are originally made of plastic and are common to break. Upgrade yours to metal to prevent future failures!
Compatible with Selected 1995-2009 Buick Models
Compatible with Selected 1995-2005 Chevrolet Models
Compatible with Selected 1995-1999 Oldsmobile Models
Compatible with Selected 1995-2008 Pontiac Models
Replaces 12565082, 24503423
See Compatibility Chart To Verify Your Specific Vehicle Year, Make, & Model
⚠ California Proposition 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
shawnroberts
Reviewed in Canada on July 20, 2023
Would buy again
Chihuahuas Are Us
Reviewed in Canada on June 13, 2023
Arrived early and was exactly what was needed.
Ronald Kreft
Reviewed in the United States on September 13, 2021
Perfect fit for 2004 Chevy Impala 3800 engine. No installation instructions are included so look at online videos as to which elbow goes where on the belt tensioner.
Christie B
Reviewed in the United States on March 8, 2021
Just as promised. Right part, good conditions and work great.
Paul S.
Reviewed in the United States on January 5, 2021
GM engineers are some stupid people. The plastic parts that these replace should never have been made. Many engines have been run dry because of these stupid parts falling apart. These, however, were made right. No more leaks and they will not fall apart.
wms
Reviewed in the United States on April 9, 2021
These are so much better than the oem plastic. Spend the money to avoid having to redo like I did.
lesa adams-gallant
Reviewed in Canada on December 4, 2017
Worked great
Michael
Reviewed in the United States on April 18, 2017
These fit well, no difference from OEM part. Had no trouble at all installing. Of course unlike the OEM pieces, which are plastic, these are metal. As such longevity should be much improved. Very good price as well. A definite recommend.
Jason Kelly
Reviewed in the United States on July 15, 2016
I own a 2002 Grand Prix Gt with the 3800 engine. Recently the elbows (which are plastic) cracked and began to leak coolant around the engine. It finally completely broke and would empty out the entire reservoir in a couple hours. I found these at a great price and they fit like they were factory made. No more leaks! My engine stays cool again and they are metal, not plastic, so I don't have to worry about them cracking or breaking down ever again!
Mike_of_bbg
Reviewed in the United States on September 7, 2015
Went ahead and installed these while doing the upper manifold and lower manifold gaskets on my 2004 Impala. After a few months and a couple thousand miles they seem to be holding just fine, and are much more confidence-inspiring than the frequently-failing plastic ones. There was a little flash molding left on the O-rings though. Thinking these are just the Dorman ones re-packaged. APDTY seems to have a few items like that.I used an old aluminum gutter spike to help remove any debris from the holes, in an outward direction. Also used a couple chunks of green scotch-brite pads to clean out the holes smooth. That and some silicone lube I'm sure helped ease the installation.
hugh forbes
Reviewed in the United States on December 22, 2014
bought them 5 months ago for buick lucerne V6 from car parts shop, orange o ring started leaking, will get dealer o ring or part and replace, i dont know if the metal has anything to do with it. ...........bad design GM
Recommended Products
