Your cart is empty.
Your cart is empty.Product Description
Specifications For
Model:8-30v Waterproof LED Backlight 6 Gang Switch Panel
Material Description:High quality aluminium
Installation:Pre-wired
Switches Available:6 Gang
Amp Rating per circuit:15amp Max
Rocker Switch:6
Breaker:6(5A x 2;10A x 2;15A x 2)
Loop Circuit:ON-OFF
Switch System: Water-resistant enclosed Rocker switch
Rating:AC 125V 16A,250V 10A;DC 12V 20A,24V 10A
Dielectric Strength:AC 1500V 1minute
Operating Temperature:-25degree to 80degree
Electrical Life:10000 make and break cycles at full load
IP Rating:IP68
Dimensions:7-1/2 inches long x 4-1/2 inches wide
More about product
* With a rubber sealing cover to maintain its water tightness, no need to worry about water when used on board.
* Overload protection by Circuit Breaker, SplashProof,anti-corrosion
* Easy to install,can be installed horizontally or vertically(Horizontally optional)
* Suitable for both 12V and 24V systems Panel is pre-wired, Complete with a 45 piece label set (for 45 different applications) Includes 6 x Stainless Steel Screw
hal
Reviewed in the United States on March 12, 2025
Very nice panel. It has main feed leads for either ground or power. (All my grounds are tied together and back to the negative post on the battery.)Very good panel for low amp things like running lights, anchor light, bilge pump. If you need to power higher amp stuff, you’d probably want a larger stand alone switch.I installed it on my aluminum center console to replace the old one. Had to enlarge the access hole about 3/4”, no big deal. It comes with sheet metal screws for mounting but I used the old nut / bolts from the previous. Worked fineI’m not 100% sure about its water resistance, it’s going to be protected, but also occasionally exposed to rain, so we’ll see. So far it’s very nice, so I give it a 5
Robert Thomas
Reviewed in the United States on January 18, 2021
This came with only a 14 AWG wire on the positive side to feed all the loads. The sum total capacity of the breakers is 50A. The negative wires are only 20 gauge but they are only for the LEDs in the switches so that's fine but it brings up another issue. This should have a negative bus bar to land multiple grounds on, poor design.The wire sizing could be dangerous if this was used close to the breaker capacities. Otherwise it could cause significant voltage drop even if it isn't reaching max capacity.Why skimp on wire sizing when the length needed to wire this correctly is so small. Made in China...
Recommended Products