Your cart is empty.
Your cart is empty.Specifications: Material:Non-woven fabric,Fiber Mounting Hole Diameter:approx.2.0cm Grit:240 (Red), 120 (Green) Suitable for:Polishing metal surface. Note: 1) All dimensions are measured by hand, there may be small deviations. 2) Color may vary slightly due to the color setting of each individual monitor. 3) Please make sure the size and shape of this item are fit for your equipment before purchase. Item included:1 x Fiber Flap Polishing Wheel Feature: 1) Made of quality fiber and abrasive paper, exquisite workmanship. 2) Perfect tool used for de-burring, rust removing etc. 3) Easy to install, low noise, working smoothly, uniform polishing effect.
Stubbie
Reviewed in the United States on June 27, 2024
This kind of wheel was new to me. Cuts fast and cool. Love it so much I am wearing it out so I'll have to get another.
Charles d Weems
Reviewed in the United States on September 20, 2023
It will not only buff the rust off of the surface but it will also buff the surface to a brushed finish.
Jimeane Astley
Reviewed in the United States on March 29, 2023
Polishing various aluminum parts
AJ
Reviewed in the United States on November 9, 2023
Once managing to fab up and apply a temp reducing bushing adapter for a fairly close fitment to the bench grinders arbor... it functioned as described. Ordering an actual reducing bushing for a exact fit.But as another alternative discovered the use of 3 Pex 1/2" crimp o-rings provided a fairly close temp adaptation.. ID is fine ...OD is just a smidge shy of being exact. But with proper tightening of mounting washers... no wobbles. ;-)
Joseph Tavares
Reviewed in the United States on April 29, 2023
Didn’t even fit on the bench grinder
Dave
Reviewed in Canada on August 9, 2022
good for shinning up parts, less abasive then the wire wheel, still leaves a bit of grain but great for pre polishing heavy corosion on aluminum(just careful of alum dust!)
Tony B
Reviewed in the United States on January 28, 2022
Well made and fits into 8" Wen grinder nicely. Haven't used it yet, but nice tight weave and limited run out
Eric
Reviewed in the United States on December 7, 2021
The sticker covers the particle board center so the thickness of the red nylon fiber is all you get, it doesn't wear any further than what you can see.
Dollar Bill
Reviewed in the United States on December 13, 2021
I machined item specific bushings/spacers to use this on my pedestal mounted buffer and was unable to successfully mount it in any position that it did not shake violently.
Recommended Products
