Your cart is empty.
Your cart is empty.58T Sprocket Wheel for #35 Sprocket 6 Holes Go Kart rear sprocket gear for #35 roller chain. #35 6 hole family sprockets and axle hub adapters. Please choose adapte size, sprocket size or combination. These sprocket wheels are designed to be used with #35 roller chain which is 3/8" pitch. These are commonly used in Go Karts. Chain wheel sprockets are made of steel and are nickel plated and the hub axle adapters are usually made of steel and are keyed but also come with a set screw to lock it to the shaft or axle. The hub adaptor is a little bigger than the shaft so it goes in smoothly but has a tight fit.
Brian
Reviewed in the United States on August 6, 2023
Cheap chinesium can't hold the power of the 212
James Neisz
Reviewed in the United States on June 9, 2023
Sprocket came looking like it had already seen a couple hundred miles on another bike, I looked past it and went to install it and just by laying it directly on top of the stock motovox 75t sprocket all the holes looked to be aligned. Tried putting it on my wheel and could only get one bolt through one hole it was off centered by the tiniest bit
jason coulter
Reviewed in the United States on May 5, 2023
to start off. The hub and sprocket each have 6 holes. However, only 3 holes align. There is a little too much slop in the holes to center the hub very easily. The nuts and bolts are also not of great quality as I had 2 that would almost strip out they were so loose and 1 that took way more than it should have to tighten
Nitro Mini Customz
Reviewed in the United States on March 6, 2023
This sprocket mounting holes do not aligned properly with the stock hub holes.
Julia D.
Reviewed in the United States on March 17, 2023
The 75T Sprocket is NOT 2 mm thick, instead it's 4mm thick. The holes around the inner circle are around 6.45mm in diameter, not 6mm as shown in the product photos.Luckily, everything else from what I can tell seems to be about accurate to what the photos show.In the Customer Questions and Answers I asked how many mm thick the 75T sprocket is, and the seller responded saying it was 2mm thick. This is incorrect.I'm giving it 3 stars because it probably does the job, but I can't give anymore than that due to inaccurate information. Due to this inaccurate information, I am unable to use the sprocket.In case it's helpful, it's weighs about 805grams.
Carlos dedos
Reviewed in the United States on December 13, 2023
Perfecto para motoras de 150cc
John
Reviewed in the United States on October 8, 2022
works great.
David w. Foster
Reviewed in the United States on October 17, 2022
Heavy steel very well-made. Money well spent.
Recommended Products
