Your cart is empty.
Your cart is empty.Product Description
- Q1: Can I connect my controller to 48V? I purchased the 36V version from you.
A: 36‑48V will work.
- Q2: How to deal with error E10?
A: 1. Check the meter and the controller docking port, there is no poor contact, plug and play, there is no wiring error. 2. Check the turn handle or booster there is no short circuit. Wiring there is no error. 3. Is not the meter with other controllers, meters and controllers must be purchased as a set of use, can not be mixed with other.
- Q3: How to set the booster?
A: P13 on the manual to set the product booster, in the case of the booster is not compatible, you need to adjust yourself to 8 or 12.
36V‑48V Waterproof Electric Brushless Controller
- This display adopts good quality materials, lightweight, rainproof, sturdy and durable
- LCD display can clearly show the state and data, backlight enables you to see scree clearly in dim environment, buttons for quick operation, easy to use
- The controller is brushless type, working silently and sensitive to the state of electric bike
- Easy to install and use, comes with mount for LCD display and suitable for 22.5mm handlebar
- Can set the power‑on password, control the lights, cruise and boost. The vehicle speed is divided into gears, the number of gear positions is 3/5/9 gears optional, and turn the handle can be selected to be divided into gears or not.
- Suitable for electric bicycles, cars, scooters
How to Use
Get the product, please be sure to match the phase first:
The intelligent identification line to plug up the identification of the motor, identification line is two green lines, plugged on, pay attention to the car overhead up, the motor will automatically run, at this time the direction of rotation of the motor if the correct, then run 10 to 15 seconds to disconnect the identification line, if the direction is the opposite, then disconnect the identification line and then plug back, the direction of the motor will be changed to positive rotation, then run 10 to 15 seconds, disconnect the identification line, the direction of the motor will be changed to positive rotation. Then run for 10‑15 seconds, disconnect the identification line, complete. After completing the identification, identification line to maintain the disconnected state, do not plug back in
G S
Reviewed in the United States on March 12, 2025
I have purchased this multiple times.. very good quality and I will purchase again.. I like the power on password function as well as its memory function.. quiet and strong compared to others of same kind
DOG
Reviewed in the United States on May 16, 2024
CONNECTORS DID'T WORK
Kevin Kulikowski
Reviewed in the United States on March 2, 2024
Ok. K
Thomas
Reviewed in the United States on September 4, 2023
I contacted to my bike and it runs and every 2 minutes stops and I have 2 release the throttle and start again for an other 2 minutes
Recommended Products