Your cart is empty.
Your cart is empty.Product Description
Snap-on installation for faster installation
High-quality terminals, can withstand 30A high current
With waterproof frame, effectively waterproof and not deformed
Mike L
Reviewed in the United States on March 30, 2024
Needed an illuminated rocker switch that could handle a 30A load and this switch works perfectly. The switch is well constructed and the LED is bright and even. Fits snug into a 30mm x 22mm hole. This switch is just what I needed and at a great price. Would definitely recommend and buy again if I needed more.
Patricia Elmore
Reviewed in the United States on July 28, 2023
This type of wiring is a wiring method where the light IS NOT always on. First, connect the two legs of the waterproof 12v switch to the positive and negative poles of the power supply, and connect the two lamp pins to the device. At this time, press the IP67 Waterproof 12v Switch, the switch key will light up, and the device will start, and then press the switch. The LED of the switch goes out and the device turns off.
Paul B Kelley
Reviewed in the United States on January 8, 2023
Seem to be nice quality. Just got started using then so don't know about the long-term. Working well for what I needed.
Thomas Schleis
Reviewed in the United States on September 9, 2022
I had my hot liquor tank switch loose it's rubber surround. These were almost an exact match and just needed to file the bottom slightly bigger. Now I feel safe again. There are 3 switches on it, so this was perfect. Now I can replace the other 2 if they fail.
Gimmy
Reviewed in the United States on December 30, 2022
The switches feel sturdy and have good toggle feedback. These are definitely water resistant, but not water proof. The light under the switch is extremely dim. I ended up taking the switch apart and found that the light is a small incandescent bulb. Since I'm using these in a 12v system I swapped out the bulb for a 12v led. Other than that the switches are great and worked well for my project.
Ronm
Reviewed in the United States on October 18, 2022
My homemade dust collector has a heavy sheet metal cyclone dust separator connected to a collection bucket and the intake of the dust impeller chassis by 6 inch hoses. Rather than manually pushing up the cyclone or worse disconnect hoses, I devised a lifting platform using 4 linear actuators. I needed an off/on switch for the control box charging a 12 volt power supply for the actuators, and associated relays. This lighted rocker switch was perfect for mounting to a plastic enclosure for this system. I was especially happy about the 30 amp, and water proof capability of the FILN 3Pcs 4 Pin Boat Marine Waterproof On Off DPST Rocker Switch Toggle Switch.
Recommended Products