Your cart is empty.
Your cart is empty.Product Description
Load Cell
Feature
4 leads, easy to use, plus 5-10V drive voltage, direct output as a voltage signal due to force changes. Works for arduino and raspberry pi.
Installation method
One end of the sensor is fixed by the screw hole, the other end is kept in a floating state, and the gravity is applied in the direction indicated.
Special attention must be paid not to directly press the white rubber part to avoid damage to the sensor.
Using a Single Load Cell with for Arduino
Connect RED wire of load cell to E+ of hx711 module.
Connect BLACK wire of load cell to E- of hx711 module.
Connect WHITE wire of load cell to A- of hx711 module.
Connect GREEN wire of load cell to A+ of hx711 module.
Connect GND of hx711 module to board GND, and VCC to board 5V pin.
Connect DT and SCK of hx711 module to any digital IO pins of board.
Mini HX711 AD Module
Description
1. The module uses 24 high-precision A/D converter chip hx711, is designed for high-precision electronic scale and design, with two analog input channels, the internal programmable gain amplifier integrated multiplier 128.
2. The input circuit can be configured to provide a bridge voltage electrical bridge (such as pressure, weight) sensor model is an ideal high-precision, low-cost sampling front-end module.
Features
(1)Two selectable differential input channels
(2)On-chip active low noise PGA with selectable gain of 64 and 128
(3)On-chip power supply regulator for load-cell and ADC analog power supply
(4)On-chip oscillator requiring no external component with optional external crystal
(5)On-chip power-on-reset
(6)Simple digital control and serial interface: pin-driven controlsno programming needed
(7)Selectable 10Hz or 80Hz output data rate
(8)Simultaneous 50 and 60Hz supply rejection
(9)Current consumption including on-chip analog power supply regulator: normal operation < 1.7mA, power down < 1uA
Parameter
Operation supply voltage range: 2.6 - 5.5V
Operating Temperature Range:-20 degree ~ +85 degree