Your cart is empty.
Your cart is empty.Everything worked as advertised. Very easy
Reviewed in the United States on January 28, 2025
Stuffenzee werks trffic lliw yub niaga
HS
Reviewed in the United States on September 29, 2024
great services
Volker B. Hildebrandt
Reviewed in the United States on August 21, 2024
fits my sawblades
Fandam
Reviewed in the United States on July 24, 2024
The inside diameter of the bushing was just a bit too tight to fit over the blade aperture of my Ryobi 5 1/2-inch circular saw. I widened the bushing's ID with a file to get it to fit.
John G.
Reviewed in the United States on May 9, 2024
Bushings are correctly sized for 7/8" OD and fit exactly on my 5/8" grinder arbor.
tom hogue
Reviewed in the United States on December 14, 2024
my fault for not converting 15.7mm to inches. they did all measure .618-.619. unfortunately that's too small for a saw blade with a 5/8 hole. my one old spacer measures .630 and is easily tapped into my new blade
Dan old guy
Reviewed in the United States on January 27, 2024
these little buggers are very hard to obtain in local storesfound them here. dimensions are right on spec.thanks for the 10 pack. only needed one but hay I loose stuff all the timeDan The Old Guy
Camper dude
Reviewed in the United States on October 29, 2023
The only issue that caused me to drop one star was the inside diameter was not as advertised. I mixed it out and it was slightly undersized, not allowing it to fit the properly sized arbor. I was able to bring it to spec with some rolled up emery, rotating both the emery and the adapter to maintain a true center. My caliper tells me I was successful in the effort.Works great both in ID and OD.
Recommended Products