Your cart is empty.
Your cart is empty.James Jenkins
Reviewed in the United States on November 21, 2024
Sturdy strong provides threaded hole for mounting/fastening.
dtellis
Reviewed in the United States on October 6, 2024
I bought these as a direct replacement for OEM wellnuts PN: 90111-KW3-003 to mount my windscreen back onto my bike.The flange of this well nut is barely 1mm (OEM is 2.5-3) so it pulled through the washer and mounting bracket when tightening the screw.When tightening the screw, the nut separated from the rubber and just drew up into the sleeve. It didn’t expand like it should to hold anything in place.I bought OEM and they work as they should.These are absolute trash and a waste of money. Just spend the xtra and get what works.
Matthew P.
Reviewed in the United States on January 8, 2024
Yup… They are perfect replacements. I have a ZX14 and it was JUST enough to replace a few. I’d suggest a larger kit if you need an entire refresh or putting on new fairings.
craig shotwell
Reviewed in the United States on May 4, 2022
Resolved a less than perfect mechanical design issue
James
Reviewed in the United States on July 8, 2021
Worked perfectly on my 2017 Africa Twin windscreen. The nuts are very easy to lose on the bottom so it’s nice to have extra.
Rob
Reviewed in the United States on June 17, 2021
The rubber seemed soft/sort of deteriorating already. Probably have to replace these again fairly quickly.
travel tools
Reviewed in the United States on May 12, 2021
Thread size matched my Africa Twin. Diameter of outside is a bit small for the AT hole. Beefed it up a bit and got it to work but may be better off with OE on this item.
Hector trujillo
Reviewed in Mexico on March 8, 2021
Excelente
Andre
Reviewed in Canada on January 22, 2021
Fits and works.
Jim R
Reviewed in Canada on April 3, 2021
Used o my Arctic Cat XF800 as the orignals were worn out.Not quite the same as the originals, I think far better.
Rob
Reviewed in Canada on April 18, 2021
There is a serious issue with this product. The brass nut does not adhere to the interior of the rubber. When the bolt is inserted and tightened, it simply pulls the nut through the rubber tube instead of creating the desired 'well" which is the whole point of these fasteners. With the 'well' not properly created, the item which it is designed to fasten isn't fastened at all. In my case a motorcycle windshield. This product actually creates a dangerous situation as a fastner for a motorcycle.
Customer
Reviewed in the United States on March 11, 2020
They had a few bad reviews but they worked perfect for me on a V Stom
Graeme Long
Reviewed in Canada on July 20, 2019
I needed new Well Nuts, as I purchased a replacement windscreen for my Kawasaki Ninja 500, and the old well nuts seemed to be permanently attached to the old windscreen. These fit my new Zero Gravity windscreen perfectly, and I was able to use them with my original screws.
Recommended Products
$10.95
$ 4 .99 $4.99